This is all straight after a clean install of Windows 10. Had issues, so I removed Ai Suite 3, used the Ai Suite cleaner, reinstalled the latest version from the ASUS website for my motherboard. I installed the AI Suite 3 that came with the motherboard from the CD. Once again, if I change the curve and put it back, hit Apply, the fan spins up and stays there. The fan continues to sit at 0% and indicates it is spinning up to 45%. I have the lowest part of the curve set to 45%. The controllable range for my rear fan (Vadar FE-140ER 2000rpm) is 31% - 100% The Rear Fan is connected to the CHA_1 4-pin fan plug on the motherboard. The second problem is somewhat the opposite. The fans' controllable range is 18% - 100% If I change the curve and then put it back to where it was, then press 'Apply', the fan returns to the curve. The set curve is about in the middle of the zone (30%) but the fan (2x Furious Vadar FFS-120 3000rpm) will continue to run at the RPM above the zone and won't settle down to the curve. The first issue is sometimes the CPU fan will sit above the 'Extreme Quiet' zone (18% - ~42%) and indicate that it's running down to my set curve. I require the additional functionality that the second version provides, however. I have just upgraded to my current specs, using Windows 10 Pro 64bit. I am totally new to these forums so please let me know if I do something wrong. I have a couple of issues with Fan Xpert 3.
0 Comments
Leave a Reply. |